You can download the latest versions of the VBOX Pit Lane Timer here.
You can find information on how to upgrade the firmware on Pit Lane Timer units here.
FIXED
- Pit Lane Entry/Exit files can now be loaded from an SD card.
CHANGE
- Reduced the minimum allowed pit lane speed limit from 40 km/h to 25 km/h
NEW
- Output CAN
- CAN Options
- Support secondary display
- Secondary pit display using Pit Lane Timer hardware (requires terminating resistor)
CHANGE
- Increase maximum pit time to 10 minutes
CHANGE
- Increased maximum Pit To Exit time to 90 seconds
- Increased Minimum Pit Time precision to 0.1 seconds
- LED precision increased:
- Red LEDs will light up when 0 seconds over Pit To Exit margin
- Green LEDs will light up when 0.1 seconds under Pit To Exit margin
CHANGE
- Retaining pit entrance and pit exit points after power cycles
NEW
- Support for the latest GPS receiver firmware
CHANGE
- Maximum Pit To Exit time increased from 30 seconds to 60 seconds
Initial release
Occasionally, Racelogic will release new versions of firmware (internal code) for the Pit Lane Timers, often to introduce new features.
You can download the latest firmware file here.
- Download the upgrade file from the link above and unzip it.
(Your unit must be registered to receive the required login details for the download, Register here) - Place the .upgrade file on the root directory of an SD card (not in the media or any other folder).
- Make sure that the unit is not powered.
- Insert the SD card into the side panel of your unit.
- Press and hold the UP button while you connect power to the unit to start the upgrade process.
- The unit will display a progress bar until the upgrade is complete.
- Power the unit off and on again to complete the upgrade.
IMPORTANT
Even if the display has been set to inverted in the settings, the buttons will keep their original functions for the firmware update process. You must make sure that you press and hold the button that points Up when the Racelogic logo is readable and above the display.