03 - LabSat 2 Hardware overview

Updated on Mar 4, 2026

Image missing
ConnectorDescriptionComment
DATAHigh speed USB 2.0 linkTransfers data to and from PC
GPS MONITORGPS Monitor - NMEAOutputs NMEA from internal GPS engine during Replay and Record
PWR12 Volt DCPower Supply Input to LabSat 2
AUX5 Pin LEMODigital In / Out – For connection of Interface Modules such as RLLSIM01
RF OUTGNSS Simulation RF OutputGNSS signal output during replay mode
RF INGNSS Active Antenna InputUsed when recording GNSS signals
CLOCK IN10 MHz ReferenceExternal reference clock input
DIGITAL I/O26 Way D-Type Connector1 – PPS Output ( refer toConnectorPin Datasection for further pin out details)
LEDsDescriptionComment
PWRPower statusGreen LED indicates power good
PLAYReplay IndicationIndicates that LabSat 2 is in Replay Mode
RECRecord IndicationIndicates that LabSat 2 is in Record Mode
BUFFERMemory Buffer statusIndicates buffer status. If status reaches F (Full Buffer) during record or replay, this indicates that the PC cannot maintain the required transfer rate.  Recorded data may be corrupt if full buffer occurs during record