Tests

You can access the menu by pressing the OK button. Use the Up and Down arrows to navigate through the menu and press the OK button to enter a submenu or change a setting. When you edit a setting, the Up and Down buttons will let you scroll through the available options for that setting and the OK button will confirm your selection. Use the Back button to exit a setting. 

This menu can be used to configure brake test/lap timing settings.

Start Speed

Defines the start speed at which the test will begin (100 km/h by default).

End Speed

Defines the end speed at which the test will end (0 km/h by default).

Corrected Dist.

Auto corrected

This sets the speed sensor to use the nearest rounded 10 km/h speed when the trigger is activated.

For example, if the trigger speed was 104 km/h, then 100 km/h would be the nominated start speed for the corrected brake stop distance.

Value

85 km/h by default.

S/F Gate Width

Defines the width of any gates set (25 m by default).

Retrigger Time

Defines the minimum amount of time needed between triggers for the second trigger to be valid. If a trigger is detected before this time, it will be ignored (1 s by default).

Lap Pulse Width

Defines the width of the pulse emitted when crossing a lap or split timeline (1 s by default).

Split to Split time

Determines whether the 'Split Time' CAN channel is either the total lap time at point of crossing the split line or the delta time between split lines.

SF - Split or Split - Split