| Velocity | |
|---|
| Accuracy | | | 0.1 km/h (averaged over 4 samples) |
|---|
| Update rate | | | 100 Hz |
|---|
| Maximum velocity | | | 1200 mph |
|---|
| Minimum velocity | | | 0.1 km/h |
|---|
| Resolution | | | 0.01 km/h |
|---|
| Latency | | | 20 ms (fixed) |
|---|
| Absolute Positioning | |
|---|
| Accuracy* with RTK | | | V: 10 mm; H: 5 mm |
|---|
| Accuracy* Standalone | | | V: 1.8 m; H: 1.2 m |
|---|
| Accuracy* with SBAS | | | V: 1.2 m; H: 0.8 m |
|---|
| Accuracy* with DGPS | | | V: 0.5 m; H: 0.3 m |
|---|
| Update rate | | | 100 Hz |
|---|
| Resolution | | | 1.8 mm |
|---|
| Distance | |
|---|
| Accuracy | | | 0.05% (< 50 cm per km) |
|---|
| Units | | | metres/feet |
|---|
| Update rate | | | 100 Hz |
|---|
| Resolution | | | 1 cm |
|---|
| Acceleration | |
|---|
| Accuracy | | | 0.50 % |
|---|
| Maximum | | | 20 g |
|---|
| Resolution | | | 0.01 g |
|---|
| Update rate | | | 100 Hz |
|---|
| Heading | |
|---|
| Resolution | | | 0.01° |
|---|
| Accuracy | | | 0.1° |
|---|
| Time | |
|---|
| Resolution | | | 0.01 s |
|---|
| Accuracy | | | 0.01 s |
|---|
| Brake Distance Accuracy | |
|---|
| Accuracy | | | ± 1.8 cm** |
|---|
Definitions
* Specifications will vary depending on the number of satellites used, obstructions, satellite geometry (PDOP), multipath effects, and atmospheric conditions. For maximum system accuracy, always follow best practices for GNSS data collection.
** Based on a trigger stop distance of < 50 m.
| Supported GNSS Signals | |
|---|
| GPS | | | L1 and L2 |
|---|
| GLONASS | | | G1 and G2 |
|---|
| CAN Bus | |
|---|
| Output data rate | | | Selectable baud rate:125 kbit/s250 kbit/s500 kbit/s1 Mbit/sSoftware controlled CAN termination. |
|---|
| Data available | | | Outputs:Satellite count, time, position, speed, course over ground, heading, vertical velocity, longitudinal acceleration, lateral acceleration, distance, DGPS statusResults:Trigger event time, trigger speed, start speed, end speed, deceleration test time, lap time, split time, radius of turn. |
|---|
| RS232 Output | |
|---|
| Output data rate | | | Up to 100 Hz |
|---|
| Data available | | | NMEARacelogic (compatible with VBOX Test Suite) |
|---|
| Ethernet Output | |
|---|
| Output data rate | | | 100 Hz |
|---|
| Data available | | | As per CAN data |
|---|
| Digital Output | |
|---|
| Signal levels | | | Low = 0 V, High = 5 V.Max frequency 4.4 kHz |
|---|
| Output type | | | Speed or Lap Beacon |
|---|
| GNSS Antenna Supply | |
|---|
| Supply voltage | | | 5 V DC |
|---|
| Input Power | |
|---|
| Input voltage range | | | 7.5 to 30 V DC |
|---|
| Power | | | 7.5 W (max) |
|---|
| Digital Input | |
|---|
| Input function | | | Brake event trigger/track marker |
|---|
| RS232 Input | |
|---|
| Input function | | | DGPS/RTK correctionsConfiguration |
|---|
| |
|---|
| Weight | 480 g (approximate) |
| Size (including connector) | 139.21 mm x 78.5 mm x 38 mm |
| Operating temperature | - 20°C to + 70 °C |
| Storage temperature | - 40°C to + 85 °C |
| IP rating | IP67 |
| Velocity | |
|---|
| Accuracy | | | 0.1 km/h (averaged over 4 samples) |
|---|
| Maximum velocity | | | 1600 km/h |
|---|
| Minimum velocity | | | 0.5 km/h |
|---|
| Resolution | | | 0.01 km/h |
|---|
| Output latency | | | 80 ms |
|---|
| Absolute Positioning | |
|---|
| Accuracy* with SBAS | | | H: 1.3 m CEP* |
|---|
| Resolution | | | 0.00185 m |
|---|
| Distance | |
|---|
| Accuracy | | | 0.05% (< 50 cm per km) |
|---|
| Resolution | | | 1 cm |
|---|
| Acceleration | |
|---|
| Accuracy | | | 1 % |
|---|
| Maximum | | | 4 g |
|---|
| Resolution | | | 0.01 g |
|---|
| Heading | |
|---|
| Resolution | | | 0.01° |
|---|
| Accuracy | | | 0.3° |
|---|
| Brake Distance Accuracy | |
|---|
| Accuracy | | | ± 10 cm** |
|---|
* SBAS enabled as default. Specifications will vary depending on the number of satellites used, obstructions, satellite geometry (PDOP), multipath effects, and atmospheric conditions. Accuracies stated to 95% CEP (Circle of Error Probable), meaning that 95% of the time the position readings will fall within a circle of the stated radius.
** Based on < 50 m brake stop distance.
| Supported GNSS Signals | |
|---|
| GPS | | | L1C/A (1575.42 MHz) |
|---|
| GLONASS | | | L1OF (1602 MHz + k* 562.5 kHz,k = –7_..., 5, 6) |
|---|
| Galileo | | | E1-B/C (1575.42 MHz) |
|---|
| BeiDou | | | B1I (1561.098 MHz) |
|---|
| CAN Bus | |
|---|
| Output data rate | | | Selectable baud rate:125 kbit/s250 kbit/s500 kbit/s1 Mbit/sSoftware controlled CAN termination. |
|---|
| Data available | | | Outputs:Satellite count, time, position, speed, course over ground heading, vertical velocity, longitudinal acceleration, lateral acceleration, distance, DGPS status.Results:Trigger event time, trigger speed, start speed, end speed, deceleration test time, lap time, split time, radius of turn. |
|---|
| RS232 Output | |
|---|
| Output data rate | | | Up to 25 Hz |
|---|
| Data available | | | NMEARacelogic (compatible with VBOX Test Suite) |
|---|
| Digital Output | |
|---|
| Signal levels | | | Low = 0 V, High = 5 V.Max frequency 4.4 kHz |
|---|
| Output type | | | Speed or Lap Beacon |
|---|
| GNSS Antenna Supply | |
|---|
| Supply voltage | | | 5 V DC |
|---|
| Input Power | |
|---|
| Input voltage range | | | 7.5 to 30 V DC |
|---|
| Power | | | 7.5 W |
|---|
| Nominal Power Consumption | | | ~ 3.9 Watts at 12 Volt input |
|---|
| Digital Input | |
|---|
| Input function | | | Brake event trigger/track marker |
|---|
| RS232 Input | |
|---|
| Input function | | | Configuration with VBOX Setup |
|---|
| |
|---|
| Weight | 480 g (approximate) |
| Size (including connector) | 139.21 mm x 78.5 mm x 38 mm |
| Operating temperature | - 20°C to + 70 °C |
| Storage temperature | - 40°C to + 85 °C |
| IP rating | IP67 |
