Measure the inner diameter of the steering wheel rim, loosen the clamp screws on the lower side of the supporting plate slightly and adjust the clamp as required.
Loosen the screws on the side so that the three clamp collars can be attached to the steering wheel rim of your car.
Insert the supporting plate into the steering wheel until the threaded studs fit the steering-wheel rim. This allows easy access to the turn screws.
Tighten up the screws on the side so that the three clamp collars are all close to the inner and outer side of the steering-wheel rim.
Screw the guide rod of the single-point suction holder into the threaded hole of sensor.
Screw the guide rod of the single-point suction holder into the threaded hole of sensor.
Turn the steering wheel 360º and observe if there is any movement between the guide rod and the linear bearing. If so, adjust the three screws on the side to center the sensor.
Turn the steering wheel 360º and observe if there is any movement between the guide rod and the linear bearing. If so, adjust the three screws on the side to center the sensor.
WARNINGS
- Be sure to install and secure the sensor and the cables in a way that does not impair the vehicle's steering.
- Exercise extreme caution when working with an airbag-equipped steering wheel as there is greater risk of injury. It is imperative that users follow the manufacturer's operating instructions for the airbag precisely. The airbag must be deactivated before use.