MFD Touch can display up to 6 defined VBOX parameters. There are 8 different data screens that can display a varying number of parameters and gauges. You can add a maximum of 10 screens.
When the unit is booted up for the first time, the 6 Numerical screen will be presented by default. If you want to add more screens, tap the Forward or Back buttons on the bottom right of the screen (or swipe left or right) to access the ADD/REMOVE SCREEN. It is always available before the first display screen and after the last display screen.
Add a new screen by tapping the Add Screen button. This will open up the ADD page selection screen, where you can choose the display type you would like to add.
Swipe left or right on the screen or use the Forward or Back arrows on the sides of the screen types to navigate through the available screens:
- 1 NUMERICAL
- 3 NUMERICAL
- 4 NUMERICAL
- 6 NUMERICAL
- ANALOGUE GAUGE
- G-BALL
- TARGET GRAPH
- BAR GRAPH
Tap the Confirm button on the bottom right of the screen to add the screen to the data screens.
If you tap the Cancel button on the bottom left of the screen, you will return to the ADD/REMOVE SCREEN without saving.
To remove a data screen, navigate to the ADD/REMOVE SCREEN and tap the Remove Screen button.
Select the required screen by swiping left or right or by using the Forward or Back arrows on the sides of the screen preview.
Tap the Confirm button on the bottom right of the screen to remove the selected screen.
Once you have added the required screens, you can move between them by tapping the Forward or Back arrows on the bottom right of the screen or by swiping left or right. You can find more information about the different screens by clicking on the images below:
You can change the name of each data screen by either tapping and holding or double-tapping the existing screen name at the top of the display. Use the presented keyboard to enter the new screen name.
To save the new name, tap the Confirm button on the bottom right of the screen. Tap the Cancel button on the bottom left of the screen to return to the data screen without saving the new name. If you have an SD card inserted in the unit, it will remember the new name after each power cycle.
You can configure each parameter by either tapping and holding or double-tapping the existing parameter area. This will open up the screen-specific menus. For more information about the screen menus, click on the relevant display screen above.
