06 - MFD Display Parameter Tables

***Display parameters calculated using UTC time, for example; Peak Deceleration must be performed either side of 11.59pm. Tests, which start before 11.59 and end after 12.00 may contain invalid data.

* A brake trigger must be present in order to use these parameters. 
 

**To set up the start and end speed for the acceleration / deceleration tests enter the CONFIG DISPLAY MENU from screens 1, 2 or 3, scroll across until the screen displays ACCEL/DECEL SETUP press OK to enter the test set-up menu.

**To set up the start and end speed for the acceleration / deceleration tests enter the CONFIG DISPLAY MENU from screens 1, 2 or 3, scroll across until the screen displays ACCEL/DECEL SETUP press OK to enter the test set-up menu.

The first 32 CAN channels currently being logged by the VBOX are selectable here. These can include internal module channels such as internal A/D parameters, ADAS parameters, IMU KF parameters and dual antenna parameters.
 

If no channels are currently being logged then you will be unable to enter this submenu.

Note: To allow the MFD to read the available CAN channels it must be connected up to a VBOX and VBOX Setup entered. Failure to do so will result in this list being blank or incomplete.

The table below shows the hex and decimal numbers associated with Kalman filter status. The VBOX can have a number of these status flags active at the same time so the resultant number shown in VBOX Tools or a logged file will be a result of adding together the numbers of the active statuses shown below.
 

 *A laser light barrier kit must be present in order to use these parameters.